10/12/2023 0 Comments Select an object in estlcam![]() ![]() But the main source of control should be in your CAM package. you can "control the feedrate" in the UCCNC window with the UCCNC feed override buttons. You should see the feed rate in the window of the UCCNC. ![]() You need to double and triple check in your aspire tool parmeters that you are in MM/MIN and you are at values of 1000 - 1500 - 2000. You should have your feed rate up at 2,600-3000mm/min and control the feed rate with the CAM package if you reduce the max speed of the machine then the machine will simply default to the max speed like you have seen. If your machine is maxing out the feed rate and plnunge rate then the feed that is being applied is higher than the max feed. V2 STEPCRAFT has 3000mm/min supported rapids.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |